110 FULL SAND/BLACK WSW CLEAR BELT RAIL/TAILGATE BAR FIT FLAT FRONT MANTEC SWC

Our mohair hoods are all proudly manufactured in house at our workshop in Oxfordshire, UK. With over 40 years’ experience working in the industry, we have been able to adapt and enhance our patterns to ensure the perfect high quality mohair hood for your Land Rover.

The mohair is mostly sourced from Germany (mohair is the same as is used on all modern German manufactured convertibles), has vybac windows, spun polyester straps and ropes, silver or black nickel-plated brass eyelets and galvanised steel side hooks with aluminium back plates where applicable.

At AWT we understand that there are a multitude of ways you can modify your Land Rover and we can be flexible to cater for these modifications if you give us a call or email to let us know! For all mohair hoods there are multiple ways of fitting these to your Land Rover. Rope on version fits exactly like a canvas hood, the sides and back fasten to the capping and tailgate by rope, roll up and fasten with straps. You need to make sure you have the relevant side and tail hooks (Available to purchase separately)

Stud on version uses Tenax fasteners to fasten the sides and back to the capping and tailgate; by unzipping the centre window panels you can roll up the sides and back which fasten using straps. You need to make sure you have the male connector on the capping and tailgate so that the fastener on the hood can connect to it. (Studs are included with this hood)

Belt rail version is only used on the sides which is a mohair covered piece of ABS attached to the sides of the hood that pull and clip under the belt rail fitting kit, you need to make sure this installed on the vehicle. (Belt rail fitting kits available to purchase separately)

Tailgate bar can only be used as a fastening method on the tailgate, on the back of the hood there is a strip of awning rail which slides into the tailgate bar. You need to make sure the tailgate bar is attached to the vehicle using two brackets (Tailgate bar kit is available to purchase separately)

Bungee version can either fit exactly like the rope on version with the sides and back fastening to the capping and tailgate with bungee or you can choose to have zips in the sides and back and then the bungee fitting is in 3 sections. You need to make sure you have the relevant side and tail hooks (Available to purchase separately). If you choose this option, please be aware the windows will be smaller.

We always ask if your vehicle has a spare wheel carrier fitted so that we can make a small cut out in the back of the hood, in order to sit neatly over the bracket of the carrier. The hoods are finished with a D shaped cover to stop the zip slider making contact with the paint work.

The window is protected throughout the process of manufacturing the hood by sandwiching it between protection paper and vinyl. The removal of the protection paper and vinyl is the last step of production before packing where the cut-out protection paper and vinyl are laid back over the window to prevent any damage during shipping.

Additional Information

Mohair – It features an acrylic/polyester, a rubber inner-layer, and a cotton backing

Window – Vybac 1mm/40 thou

Straps – Polyester

Binding - Polypropylene

Ropes - Polypropylene

Side Hooks - Galvanised steel

Side back plates – Aluminium

Buckles – Cam locks

Eyelets – Brass Nickle Plated or Black

Studs – Tenax Fasteners

Belt Rail – 3mm ABS

Bungee – 4mm Elastic

Thread

External Thread – Tenara, 15-year life, all weather, typically used in the sailing industry

Inside Top – Polycotton 20 Gauge, eliminates any chances of leaking through the top by swelling

through the hole

All Other Stitching – Nylon 40 Gauge